Fungus on the ceiling in the bathroom How to get rid of, how to prevent the emergence of

Fungus on the ceiling in the bathroom How to get rid of, how to prevent the emergence of

12 October 2017



Dampness - a favorable environment for the growth of fungiDampness - a favorable environment for the growth gribkovGribok on the ceiling in the bathroom comes from the fact that in this room are formed positive conditions for the germination of the pathogen. It is not a plant, a bacterium, a fungus that is. This means that the bulk of it - is the root of what is hidden in a layer of concrete or finishing. And there it is due to excessive moisture, poor provetrivaemosti premises or breach of finishing technology.


Get rid of it quite difficult. For example, if a major ceiling covered with a layer of ceramic tiles, even clean off the fungus - it will appear again, and quickly. And all because of the root, which is to remove mechanically - will not work (unless completely replacing the ceiling tiles, but in apartment buildings it is almost impossible).

Mold on the ceiling in the apartment

Mold - a fungus spore-forming. The spores are deposited on the lung. Easily contaminated - the emergence of diseasesMold - a fungus spore-forming. The spores are deposited on the lung. Easily contaminated - the emergence of diseases

What helps against mold on the ceiling in the apartment? Very good effect on the treatment of fungal pesticide products. And after the root is eradicated, it is recommended to carry out additional pesticide treatment that penetrates the wall. On top of all this it is grounded or covered with a layer of plaster. If the fungus does not do anything, but just to plaster the place of its distribution, then very soon and it will appear on top of the liner.

The easiest way to deal with fungus - its prevention.

To do this, each apartment after the repair is recommended:


  • handle pesticides ceiling (better for them not to save as cheap - very toxic and unsafe);
  • install forced ventilation even in the bathroom, but better - and in the kitchen, on the balcony (will work on blowing);
  • annually scrutinize all trim for signs of the fungus.

Mold on the ceiling in the bathroom: how to fight it

Despite popular belief, mold in the apartment almost has nothing to do with the fungus. Yes, they appear under the same conditions, but with the mold cope times easier. Its quite easy to treat with a solution of bleach and scrub thoroughly with ceramic tile joints (if used). There is no "root" at her almost none. There are no more germs, but they do not go deep wall (but on plaster - easy).

More mold propose to deal with copper sulfate, but it is a very harmful substance (if inhaled), but cheap. You can apply if temporarily in an apartment no one is planning to stay. But such "anti-fungal" treatment of any lichens will not help. Top "pest" ball will be really eliminated, but - temporarily.

Also with mold can be dealt with by:



  • citric acid solution;
  • white;
  • means for cleaning of sanitary equipment;
  • hydrogen peroxide;
  • vinegar (preferably - at least 20 percent concentration);
  • technical alcohol (denatured).

All of these tools are very effective, they can be combined or perform processing several times, changing the active ingredient.

ceiling processing of the fungus: how

To ceiling is never covered with any mold or fungus, should be under construction or repair carry out processing of all pesticides room (not just the ceiling), without paying attention to what the top is facing.

As soon noticed the darkening in the corners of walls - once processing begins to mold not to spray at all the roomAs soon noticed the darkening in the corners of walls - once processing begins to mold not to spray at all the room

Handling it is better to trust the professionals, and only if, and to do your own, be sure to observing the elementary rules of protection when working with toxic substances.

What pesticides are popular when the data types of work? For example, "Captain America." Pretty cheap, but effective means. It is recommended to treat the ceiling three times, with a period of 2-3 days. On top of all this is primed emulsion paint (you can plaster, and even whitewashing), and only then mounted facing material, whether it be drywall, plastic or wood. They are, incidentally, also must be treated against fungi. Plastic - not necessarily. Drywall - only if its processing is not taken care of by the manufacturer. Wood (filing) - if it is not lacquered, not beautiful and not primed. By the way, for the latter approach even PVA glue solution and distilled water. On top of this will need to be varnished. Adding a high-quality finish of ventilation - worry about the appearance of the fungus (even if it was before) is no longer needed.

Particular attention should be paid to:

  • joints of concrete slabs (in prefabricated houses);
  • brick seams at the ceiling (walls).

If necessary, these parts are opened, processed, sealed with cement mortar again. The only way to completely remove the fungus.

Tips to handle than the ceiling after a leak

Before processing weathered room, dry wall. Only then start processing the walls and ceilingBefore processing weathered room, dry wall. Only then start processing the walls and ceiling


If mold or fungus appeared after the leakage from the neighbors above (or a damaged roof covering, if it is a private home), we first need to thoroughly dry the ceiling. Close the concrete layer wet in any case it is impossible, since the water can not evaporate and will only lead to the growth of the most lichens.

The shrinkage is performed? Not only mechanically (termofenom exposure at high temperature), but the use of chemical reagents that are contacted with water and absorb it (abstract away).

Leakage can occur due to mechanical damage of the riser. Naturally, in this case, should immediately be taken for plumbing repairs. And then - to engage in the processing of the ceiling. It then uses the polyacrylate. This is the stuff of which are also now creating diapers. This small crystals that are able to absorb the volume of water which is 10 times the size of the substance itself. And while the polyacrylate is capable of "pulling" water from the concrete. However, the process is not fast. And then the ceiling of the processing is done in the same way as with the simple removal of the fungus.

That is, it is necessary in case of flooding or leakage:

  • completely drain the rough ceiling;
  • replace the lining material;
  • hold treatment against fungal capital ceiling and walls (recommended).

The process of the ceiling in the bathroom mold: Ways

Use disinfectants for the disinfection of moldUse disinfectants for the disinfection of mold


With the mold in the bathroom handle very simple. In principle, it helps to even a light soap solution. If we add acetic acid (about 20 percent concentration) in it, such a composition would destroy spores and by means of which mold multiplies. However, we must be prepared that these treatments need several.

More "aggressive" and at the same time effective option - processing of ammonia, only after the apartment is worth an awful stench. But on the mold in the next 3-5 years, just do not have to worry.

Ammonia can be replaced with denatured alcohol (aka - the technical spirit essence). That's just get it now - it's a problem.

You also need to mention the dirt road, which is composed of pesticides. She's all simple - the ceiling just whitewash closed in several layers of what you can do mount finishing.

When you remove mold must be remembered:

  • It is necessary to eliminate the cause of its occurrence (high humidity with temperature in the amount of more than 24 degrees, poor ventilation);
  • after removal - continue prophylactic treatment at least in the next 3 months;
  • trim is also treated against mold and mildew.

Fungus on the ceiling in the bathroom to get rid (video)

And by the way, the mold is always a consequence of a breach or failure of equipment repair ventilation. If the ceiling has been treated in advance, and in the house forced ventilation is functioning, even if the humidity is as high as 80 percent - it will not cause any fungus or mold. And most often it starts to appear at the joints of panels or tiles. Therefore, the joints should be treated several times a year with an alcohol or vinegar solution. 

Комментарии

Leave a Reply

Your email address will not be published. Required fields are marked *

38 + = 42

map